Short answer
A solid TPMS light means at least one tyre is significantly below its set pressure, commonly around 20 to 25% low, so check all four tyres with a gauge and inflate to the door placard figure as soon as you safely can. A light that flashes for about a minute and then stays on usually means a fault in the system, such as a dead sensor battery. If the light comes on with a sudden pull or noise, slow down and stop somewhere safe.
In the first cool week of December, our WhatsApp fills up with photos of the same yellow symbol. Owners in Mirdif and Al Barsha start their cars at 6 in the morning, the outside temperature has dropped to 17°C, and the tyre pressure warning comes on. By the time they reach the office on Al Khail Road, the light has gone out again. Most of those cars do not have a puncture. The air simply contracted overnight, and the tyres were already a little low. Then there is the other kind of message: a light that came on suddenly on the E611 with a thumping noise. That one is a puncture.
Same light, very different situations. This guide helps you tell them apart.
What does the TPMS warning light look like?
It is a yellow or amber symbol shaped like a cross-section of a tyre, a horseshoe with a flat bottom and a ridged edge, with an exclamation mark in the middle. Some cars show a picture of the car from above with the low tyre highlighted, and many show the pressure of each tyre on the dashboard screen. TPMS stands for tyre pressure monitoring system.
Is a solid TPMS light different from a flashing one?
| What the light does | What it usually means | What to do |
|---|---|---|
| Comes on solid and stays on | One or more tyres is well below set pressure | Check all four tyres with a gauge, inflate to placard |
| Flashes for around 60 to 90 seconds, then stays solid | System fault: sensor battery, damaged sensor, or unpaired sensor | Check pressures manually, then have sensors diagnosed |
| Comes on in the morning, goes off after driving | Tyres are borderline low; cold air reads lower | Top up to placard pressure when cold |
| Comes on suddenly with a pull, noise or vibration | Fast puncture or tyre damage | Slow down, stop safely, inspect |
| Comes on after a tyre change or rotation | Sensor not relearned, damaged, or missing | Relearn or check sensor positions |
What should I do when the tyre pressure light comes on?
- Look and listen. If the car is pulling, vibrating or making a flapping noise, slow down and pull over somewhere safe, away from traffic.
- If it feels normal, continue gently to a petrol station or a safe car park.
- Check all four tyres with a gauge. If your car shows individual pressures, compare them with the door placard.
- Inflate to the placard figure. If the tyres are hot from driving, add about 2 to 3 psi above placard, then re-check cold the next morning.
- Inspect the tread for nails, screws or cuts, and the sidewalls for bulges.
- If one tyre keeps dropping over a day or two, you almost certainly have a slow puncture. Book a repair before it goes flat.
A tyre running 25% under pressure in UAE summer heat flexes far more than it should, builds heat and is at real risk of failure. The light is not a nuisance. Many of the summer blowouts we see started as a slow leak the driver ignored. Read why tyres burst in Dubai summer for the full picture.
TPMS light on and a tyre keeps losing air? WhatsApp us your location. Puncture repair starts from AED 49 per tyre, done at your home, office or roadside.
Why does the TPMS light come on in cold mornings?
Air pressure changes with temperature, roughly 1 psi for every 5 to 6°C. A tyre set to 33 psi on a 40°C afternoon in October can read 29 or 30 psi on a 17°C morning in January. If it was a little low to start with, that drop is enough to cross the warning threshold. As you drive, the tyres warm up, pressure rises, and the light goes off. The fix is simple: set pressures cold, in the morning, to the placard figure.
Summer works the other way. Pressure rises during the day, which can mask a slow leak until the evening. Our tyre pressure guide and the post on correct pressure for UAE summer explain how to adjust across the year.
Why is my TPMS light on after a tyre change?
This is one of the most common calls we get. There are a few usual causes:
- The sensors need relearning: many cars, especially Japanese and American models, need a relearn procedure after rotation or new tyres so the system knows which sensor is in which corner.
- A sensor was damaged during fitting: sensors sit inside the rim on the valve. Careless tyre changing can break them. We position the bead breaker away from the valve to avoid this.
- The spare has no sensor: if you fitted the spare, the system may be looking for a sensor that is now in your boot.
- Winter or aftermarket wheels without sensors: rare in the UAE, but we see it on imported cars.
- Sealant from a repair kit: tyre sealant can clog the sensor. Read more in spare tyre vs repair kit.
TPMS sensors use a valve with a seal and nut that can perish in heat. When fitting new tyres, ask for a service kit or a new valve. A tyre valve replacement starts from AED 15 for standard valves; sensor service kits cost more.
How long do TPMS sensor batteries last?
Most direct TPMS sensors have a sealed battery that lasts somewhere around 5 to 10 years, depending on the make and how much the car is driven. Heat does not help. When one dies, you usually get the flashing-then-solid pattern, and that sensor is replaced as a unit. On a car that is seven or eight years old, if one sensor fails the others are often not far behind, so some owners replace all four at once.
Direct vs indirect TPMS: what is the difference?
Direct systems have a pressure sensor inside each wheel. They show exact pressures and react quickly. Indirect systems, used on some European and Japanese cars, have no sensors. They use the ABS wheel speed sensors to spot a tyre turning faster than the others, which happens when it loses pressure. Indirect systems need a reset from the car's menu after you adjust pressures or fit new tyres, or they will give false alarms. Your owner's manual tells you which you have.
The TPMS light is the cheapest tyre inspector you will ever have. When it comes on, it is giving you a chance to fix a 49 dirham puncture before it becomes a 400 dirham tyre.
How do I reset the TPMS light?
First, fix the cause: correct the pressures or repair the puncture. Then, depending on the car:
- Many cars reset by themselves after driving 10 to 20 minutes above around 25 km/h once pressures are correct.
- Some have a TPMS reset button, often under the steering wheel or in the glovebox.
- Others reset through the dashboard menu under tyre or vehicle settings.
- Some need a relearn tool or a specific sequence. We carry a TPMS tool on our vans for common makes.
If the light will not reset after pressures are correct, you probably have a sensor fault, not a tyre problem. Our 24-hour tyre service can check sensors as well as tyres, and the tyre pressure check near me page lists where we come to in Dubai, Sharjah and Abu Dhabi.
Light still on after inflating? WhatsApp us a photo of the dashboard and your car model. We will tell you whether it is a tyre or a sensor, and fix it on site.