A new valve requires the tyre to be partly or fully taken off the rim, so we usually do it with other work such as a puncture repair or tyre change. On cars with tyre pressure monitoring, we replace the valve parts on the sensor without damaging it.
What's included
- Leak test at the valve stem and core
- Breaking the bead and removing the old valve
- Fitting a new rubber valve or TPMS service kit
- New valve core and cap
- Reinflation and leak test
- Balance check if the tyre was fully demounted
Signs you need tyre valve replacement
- Bubbles at the base of the valve with a soapy-water test
- Visible cracks on the rubber stem when you bend it gently
- A tyre losing air with no puncture found
- Missing valve cap and sand inside the valve
- TPMS valve corroded or bent
- The valve wobbles or leans when you check pressure
How we do it
- Find the leakWe spray the valve and the tread. If bubbles come from the valve, it is replaced. If from the core only, a new core may be enough.
- Break the beadThe tyre is deflated and the bead pushed away from the rim to reach the valve hole.
- Fit the new valveThe old valve is removed and a new one pulled through. For TPMS sensors, the seal, nut and core are replaced to the right torque.
- Reinflate and testThe tyre is reseated, inflated and checked again for leaks.
What changes the final price
| Factor | How it affects the price |
|---|---|
| Valve type | Rubber snap-in valves are cheapest. Metal clamp-in valves on performance cars cost more. |
| TPMS sensors | Replacing seals on a sensor costs more, and a failed sensor needs a new unit and programming. |
| Standalone or with other work | Done during a tyre change or repair, the valve is just the part price. On its own, a call-out applies. |
| Number of valves | We recommend replacing all four if one has cracked from age. |
Valve types we fit
| Valve type | Found on | Notes |
|---|---|---|
| Rubber snap-in | Most cars without TPMS | Cheap, replace with every new tyre |
| Metal clamp-in | Performance and high-speed tyres | Needs correct torque and new seals |
| TPMS sensor valve | Most cars from around 2015 on | Sensor reused, seal and core replaced |
| High-pressure truck-type | Vans and some 4x4s | Rated for higher pressures |
Why valves fail in the UAE
Valve rubber is thinner than tyre rubber and sits right at the rim where heat from brakes and the road builds up. Combine 45°C air, sun on the wheel and hot brake discs from stop-start traffic on Al Khail Road, and valves age quickly. Missing caps let sand into the core, which stops it sealing. Check our tyre damage causes page for the valve zone.
Caps are not decoration. They keep sand and dust out of the valve core. If you lose one, any metal or plastic cap will do. We fit new ones with every service.
TPMS and valve problems
If your tyre pressure light is on but the tyre looks fine, the cause might be a slow valve leak or a sensor fault. Our post on the TPMS warning light helps tell the difference. We can test sensor battery and signal and replace a dead sensor if needed.
Aerosol tyre sealants can block TPMS sensors and ruin them. If you have already used one, tell us before we start.
Tyre Valve Replacement near you
We send vans to every area below and many more. Pick yours for local arrival times.
